Removal And Replacement Of Pump Motor - Hoshizaki KMD-901MWH Service Manual

L. Removal and Replacement of Pump Motor
1) Turn off the power supply.
2) Remove the front panel. Remove the insulation panel. Remove cube guide B, then
remove cube guide A. Remove the overflow cap, overflow pipe, and water shield. See
Fig. 3.
3) Remove the drain plug and drain the water tank. Replace the drain plug, water shield,
overflow pipe, overflow cap, cube guide A, and cube guide B in their correct positions.
Be careful not to cross thread the drain plug or overflow pipe. Replace the insulation
panel in its correct position.
4) Disconnect the pump motor wiring connector.
5) Disconnect the hoses attached to the pump motor assembly.
6) Remove the two screws securing the pump motor bracket and remove the bracket and
pump motor.
7) Remove the pump motor from the bracket. Remove the necessary parts from the old
pump motor assembly. Inspect the parts and replace any parts if needed. Install the
parts on the new pump motor and attach it to the bracket.
8) Install the new motor, and replace the removed parts in the reverse order of which they
were removed. Be sure to reattach the green ground wire.
9) Turn on the power supply and check for leaks.
10) Replace the front panel in its correct position.
Overflow Cap
Fig. 3
Overflow Pipe
Cube Guide A
Water Shield
Drain Plug
Cube Guide B
51