[B] Km-150Bwf; Controller Board; [A] Solid-State Control; [B] Controller Board - Hoshizaki KM-150BAF Service Manual

2. CONTROLLER BOARD

[a] SOLID-STATE CONTROL

1) A HOSHIZAKI exclusive solid-state control is employed in KM-150BAF and
KM-150BWF Crescent Cubers.
2) A Printed Circuit Board (hereafter called "Controller Board") includes a stable and
high quality control system.
3) All models are pretested and factory-adjusted.

[b] CONTROLLER BOARD

1. Fragile, handle very carefully.
2. A controller board contains integrated circuits, which are susceptible to
failure due to static discharge. It is especially important to touch the
metal part of the unit when handling or replacing the board.
3. Do not touch the electronic devices on the board or the back of the board
to prevent damage to the board.
4. Do not change wiring and connections. Especially, never misconnect
K3, K4 and K5, because the same connector is used for the Thermistor
and Float Switch. K4 is not connected.
5. Do not fix the electronic devices or parts on the board in the field.
Always replace the whole board assembly when it goes bad.
6. Do not short out power supply to test for voltage.
CAUTION
9