Removal And Replacement Of Fan Motor; Except Water-Cooled Model; Removal And Replacement Of Water Valve - Hoshizaki KM-150BAF Service Manual

11) Connect the Thermistor leads through the bushing of the Control Box to the K3
Connector on the Controller Board.
Note: Do not cut the leads of the Thermistor while installing it.
12) Replace the Control Box Cover and the panels in their correct positions.
13) Plug in the icemaker, and turn on the power supply.
11. REMOVAL AND REPLACEMENT OF FAN MOTOR - EXCEPT
WATER-COOLED MODEL
1) Turn off the power supply, and unplug the icemaker.
2) Remove the Front Panel and slide out the refrigeration base.
3) Remove the screws and the Fan Shroud.
4) Remove the Fan Blade.
5) Remove the closed end connectors of the Fan Motor.
6) Remove the Fan Motor Bracket.
7) Remove the Fan Motor from the Bracket.
8) Install the new Fan Motor, and replace the removed parts in the reverse order of
which they were removed.
9) Slide in the refrigeration base and replace the Front Panel in its correct position.
10) Plug in the icemaker, and turn on the power supply.

12. REMOVAL AND REPLACEMENT OF WATER VALVE

1) Turn off the power supply, and unplug the icemaker.
2) Close the Water Supply Line Shut-off Valve.
3) Disconnect the water supply piping.
4) Remove the Top Panel.
5) Disconnect the Valve Outlet Tubing by releasing the Clamp.
6) Disconnect the Terminals from the Water Valve.
47