Table 7 Boot Menu Commands - HP 9000 V-Class Operator's Manual

Table 7 Boot menu commands
Command
AUto [BOot|SEArch ON|OFF]
BOot [PRI|ALT|path args]
BootTimer [time]
CLEARPIM
CPUconfig [proc] [ON|OFF]
DEfault
DIsplay
ForthMode
IO
LS [path|flash]
OS [hpux|sppux]
PASSword
Chapter 4
Description
Displays or sets the Autoboot or Search flag. If
Autoboot is on, the system boots automatically
after reset. If AutoSearch is on, the system
searches for and displays all I/O devices that the
system can boot from.
Initiates the boot sequence. A default or specified
path to the boot device can be used.
Displays or sets a delay time for the system to
wait for external mass storage devices to come
online.
Clears (zeros) Processor Internal Memory (PIM)
storage after a system crash. CAUTION: this
command can delete important troubleshooting
information; do not enter the CLEARPIM
command unless directed to.
Displays or sets the configuration of processors.
Sets the system environment variables to defined
values and changes certain HP variables so that
HP-UX can boot.
Displays this menu.
Switches to the Forth OBP interface. For use by
service personnel only.
Displays all I/O devices in the system whose SCSI
controller cards are enabled.
Displays the LIF contents (boot or flash volume)
of a device.
Displays or sets which OS is going to boot—HP-
UX or SPP-UX. For V-Class, this should be set to
HP-UX.
Defines the password used to control access to
ForthMode. Same as UNIX password command.
Firmware (OBP and PDC)
HP mode boot menu
47