Replacing Items - Right End Bell - TurboChef 3240 Service Manual

A- 8 A P P E N D I X A - R E P L AC I N G O V E N CO M P O N E N TS

Replacing Items - Right End Bell

WARNING: Before removing or replacing any oven component, thoroughly read the safety
instructions found at the front of this manual and Oven Systems (pages 21-28). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in
serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from
the wire harness (where applicable).
Bracket, Gear Drive Controller (2 if split belt)
RTD Probe
Gear Drive (2 if split belt) **
Wire Harness, LOV, Signal, Gear Drive
Cord, Power, 12/3, SOOW, NEMA L620
**NOTE: For blower motor detail, see page A-12.
**NOTE: For gear drive detail, see page A-10.
Gear Drive Controller (2 if split belt)
Wire Harness, Conveyor Drive AC
Blower Motor *
EMI Filter
Bracket, EMI Filter
Fuses
Fuse Block
Blower Motor Controller
Relay, K3, 24 VDC, 20A
Display
Cable, Display, Power, 2-Pin
Cable, Display, Ribbon
Control Board
Power Supply
Speaker
Transformer, Burner
Wire Harness, K3 Relay and Transformer
Smart Card Reader
Cable, Smart Card Reader