Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 31

⑧
⑨
⑩
⑪
⑫
Procedure
1. Open the "SIDRIVE IQ Config" application.
2. Open the overview page.
3. Select an asset from the "Visible" tab.
4. Tap on "Connect".
SIMOTICS CONNECT 400
Operating Instructions, 05/2020, A5E50161952A AA
Status of the connectivity module battery:
● "Green" status: sufficient charge
● "Red" status: low charge, 30% or less
Note: Replace the battery in good time. If disturbances occur in data transmission, replace
the batteries (Page 63).
Last time of connection of the selected connectivity module with SIDRIVE IQ Config, with date
and time.
"Connect" button to establish a connection to the connectivity module
Update status of the firmware of the connectivity module (display is not supported in the current
version) and display of the currently installed firmware version
Status of the connectivity module
6.3 Establishing the connection to the connectivity module
Commissioning
29