Ê Fit the RMM3 module into its installation location (1 / 2).
Ê Route the RMM3 cable down along the system board as shown.
Figure 39: Installing the RMM3 module (C)
Ê Fit the two tabs on the RMM3 module into the centering holes on the chassis
front (see circles).
Ê Secure the RMM3 module with two screws.
Ê Close the server as described in
PRIMERGY CX120 S1
Replacing the Remote Management Module (RMM3)
section "Closing the server" on page
Service Supplement
31.
49