Repair And Maintenance - Razor E-PUNK Owner's Manual

REPAIR AND MAINTENANCE

Turn power "OFF" before beginning repair or maintenance:
• Read the instructions
• Remove charger plug
• Turn the power off
Adjusting the Brakes
Tool Required: 10 mm Allen Wrench
1
To adjust brake cable play,
thread the brake lever adjuster in or
out 1/4 to 1/2 turn until the desired
brake adjustment is attained. Most
adjustments are complete at this
step. If brake still needs further
adjustment, proceed to step 2.
Front Tire Replacement
Tools Required: Two (2) 16 mm Wrenches
1
Using two (2) 16 mm wrenches, loosen the axle bolt. Remove wheel and install replacement wheel. (Note the
sequence of the hardware)
Need Help? Visit our website for product support, a list of authorized service centers in the US and customer service contact information at www.razor.com.
Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is
listed at the back of this manual.
• Secure the product under repair
• Exercise caution around
exposed parts
2
If brake is too tight or loose, use
a 10 mm wrench to adjust the brake
cable accordingly.
8-5
8-3
8-1
8-4
8-2
• Contact Razor customer service
if unsure about any repair or
maintenance
• Repair and maintenance should
be performed by an adult only.
B
A
3
Inspect the brake pads (A) for
proper alignment against the wheel
or excess wear. To realign brake
pads, loosen the fixing nut (B) and
adjust the pad to contact the rim.
Re-tighten and readjust as needed.
Verify proper brake function prior to
riding the E-Punk.
8-3
8-4
7
Note: Front wheel
hardware sequence
Right Side (Push-Button Throttle)
8-4 Spacer
Fork
8-3 Washer
8-1 8-2 Spring Washer
8-1 M10 Locknut
Middle
8-2
8-5 Front Axle Bolt
Left Side (Brake)
8-4 Spacer
Fork
8-3 Washer
8-2 Spring Washer
8-1 M10 Locknut