Before You Begin - Razor E-PUNK Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the E-Punk was 95 percent assembled and packed at the factory, there should not be any problems,
even if the box has a few scars or dents.
MAKE SURE POWER IS TURNED "OFF" BEFORE CONDUCTING ANY ASSEMBLY OR
MAINTENANCE PROCEDURES.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 12 minutes for assembly, not including initial charge time.
Allow up to 12 hours for charge (see page 5 for charging information).
Charger
(Note: Charger design may
vary from one shown)
Charger Port
ON/OFF Switch
Hub Motor
Required Tools
5 mm Allen Wrench
6 mm Allen Wrench
(Included)
Need Help? Visit our website for product support, a list of authorized service centers in the US and customer service contact information at www.razor.com.
Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is
listed at the back of this manual.
2.
Seat
Frame
1.
Brake Lever
Push-Button
Throttle
Front Tire
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
ELECTRIC PRODUCT. The E-Punk
has been built to certain Razor
design specifications. The original
equipment supplied at the time
of sale was selected on the
basis of its compatibility with
the frame, fork and all other
parts. Certain aftermarket
products may not be compatible
and will void the warranty.
Product ID Locations:
(See locations to the left)
1. Under the rear frame
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• E-Punk
• Charger
• Owner's Manual
• Allen Wrenches