Dometic CAM1000 Installation And Operating Manual page 9

CAM 1000 / BSC 01
• To prevent damage to the cables when laying them, ensure that they are always far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans,
heaters, etc.).
• Attach the cables securely in the vehicles to prevent tripping hazards. This can be performed by
using cable binders, insulating tape or gluing in place with adhesives.
• Protect every through-hole made in the bodywork against water penetration by suitable meas-
ures, e.g. by using a cable with a sealant and by spraying the cable and the cable sleeve with
sealant.
Key for circuit diagram
No. Designation
1 Green connection plug:
2 Yellow connection plug:
3 Red/black wire:
4 Red wire:
5 Green wire:
6 White wire:
7 Black wire:
8 Gray wire:
9 Violet wire:
10 Yellow/orange wire:
11 Blue wire:
I
NOTE
• In Germany and Austria, special requirements apply for the operation to fulfill the
operating licence.
• CAM1000 / BSC01 may only be operated with the M75LXAHD monitor.
• It is important for the compliant operation of the system that it cannot be switched
off manually. The CAM1000 / BSC01 must therefore be connected via camera
input CAM3 of the M75LX AHD monitor. The corresponding blue control line
switches the system on and off.
The following connections must be implemented:
➤ Connect the control cable of the GPS receiver (blue) with the blue CAM3 control cable of the
monitor.
EN
Description
Audio output to loudspeaker
CVBS video output
Buzzer for acoustic signal
Connection to ignition (ACC) 12 V/24 V
R = reverse gear 12 V/24 V
(no object detection)
Indicator 12 V/24 V
Connection to ground
RX RS232 for firmware update
TX RS232 for firmware update
Cable bridge for activation of operating mode A or B:
Loop closed = operating mode B 165° FOV
Loop open = operating mode A 140° FOV
GPS output 12 V/24 V for switching on the monitor
Connecting the CAM1000 / BSC01
9