Using The Cam1000 / Bsc01 - Dometic CAM1000 Installation And Operating Manual

Using the CAM1000 / BSC01

✓ The system will automatically be activated and deactivated via the GPS signal at >30 km/h.
➤ Connect the control cable of the monitor and the camera for the reverse gear (green) with the
vehicle's reverse gear signal.
✓ The camera provides an image but the object detection is deactivated.
8 Using the CAM1000 / BSC01
I
NOTE
On the initial start-up the GPS receiver must save the satellite position. This may take up
to 10 minutes.
8.1 Detection range
The detection range of the CAM1000 / BSC01 is divided into two zones:
• Visible area: depending on vehicle height in operating mode A or B
• Active area: 8 m x 4 m
I
NOTE
No vehicle parts may protrude into the active area because the camera cannot detect
a possible object at this point.
8.2 Test indicator when switching on
See fig. b
I
NOTE
The video system switches to standby as soon as the ignition is switched on. The sys-
tem is activated depending on the speed from a speed of less than 30 km/h. The cam-
era image appears.
The test indicator allows the camera to be correctly aligned with the front of the vehicle. The refer-
ence line (fig. b 1) shall be at least in alignment with the front of the vehicle. The active area
(fig. b 2) is marked as a red area in the video for 6 seconds.
I
NOTE
In night mode with ambient lighting below 10 lux, the camera switches to black and
white mode.
The CAM1000 / BSC01 is automatically activated when the ignition is switched on.
As soon as an obstacle is in the active area, the dynamic arrow indicator (fig. b 3) appears in the
display. If the audible signal is connected, an evenly repeating beep will sound.
10
CAM 1000 / BSC 01
EN