Safety And Installation Instructions - Dometic CAM1000 Installation And Operating Manual

Safety and installation instructions

2 Safety and installation instructions
The following texts are only a supplement to the illustrations on the supplementary
sheet. They do not contain the full installation and operating instructions. Please
observe the illustrations on the supplementary sheet.
Please observe the prescribed safety instructions and stipulations from the vehicle
manufacturer and service workshops.
Observe the applicable legal regulations.
The manufacturer accepts no liability for damage in the following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical influences and incorrect connection voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
Note the following instructions during installation:
!
WARNING!
• Secure the parts installed in the vehicle in such a way that they cannot become loose
under any circumstances (sudden braking, accidents) and cause injuries to the occu-
pants of the vehicle.
• Do not install the parts anywhere in the vehicle where an airbag may open. This could
cause injury if the airbag deploys.
• Inadequate supply line connections could result in short circuits, causing:
– Cable fires
– The airbag being triggered
– Damage to electronic control devices
– Electrical malfunctions (indicators, brake light, horn, ignition, lights).
! CAUTION!
• Secure the parts installed in the vehicle in such a way that they cannot become loose
under any circumstances (sudden braking, accidents) and cause injuries to the occu-
pants of the vehicle.
• Secure any parts of the system concealed by the bodywork in such a manner that they
cannot be come loose or damage other parts or cables, or impair vehicle functions
(steering, pedals, etc.).
• Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the airbag, etc.) may only be per-
formed by qualified specialists.
A NOTICE!
• When working on the electrical system, the batteries must be separated from the
vehicle ground. This applies to the main and additional batteries.
4
CAM 1000 / BSC 01
EN