Table of Contents
Advertisement
6
Securing the Belt Covers
Parts needed for this procedure:
2
Bolt (5/16 x 1-1/4 inches)
2
Retaining nut (5/16 inch)
2
Push nut
Procedure
Note:
Perform this procedure for the right and left
side belt covers.
1.
Remove the hand knobs securing the belt
covers to the mower deck.
2.
Remove the belt covers.
3.
Install a retaining nut at the forward hole in the
deck bracket
(Figure
1. Belt cover
2. Mower deck
3. Retaining nut
4. Deck bracket
4.
Install the belt cover with the bolt (5/16 x 1-1/4
inches) and push nut (5/16 inch) as shown in
Figure
8.
5.
Install the hand knob.
8).
Figure 8
5. Bolt (5/16 x 1-1/4 inches)
6. Hand knob
7. Push nut
7
Securing the Seat Plate
Parts needed for this procedure:
1
Bolt (5/16 x 1-1/4 inches)
Procedure
1.
Install a bolt in the seat plate to the secure it.
2.
Locate the hole in the front, right side of the seat
plate, in front of the manual housing.
3.
Install a bolt (5/16 x 1-1/4 inches) in the hole to
secure the seat plate
1. Bolt (5/16 x 1-1/4 inches)
8
Installing the Decals
g004785
Parts needed for this procedure:
1
Stability decal, 138-8202
1
Sound decal, 138-8200
1
Safety decal (106-6754)
Installing the Decals
1.
Thoroughly clean the areas where you are
installing each decal.
2.
Dampen the area with water or mildly soapy
water.
3.
Install the decals as follows:
9
(Figure
9).
Figure 9
2. Manual housing
g030859
Advertisement
Table of Contents
