Table of Contents
Advertisement
2.
Install the floor-plate latch to the frame using 2
carriage bolts (1/4 x 3/4 inch) and 2 locknuts
(1/4 inch)
(Figure
3.
Remove the 2 locking nuts from the lock
assembly.
4.
Insert the lock assembly into the hole in the floor
plate with the catch facing to the left.
5.
Install the locking nuts onto the bottom of the
lock assembly to secure it in place.
Note:
The mounting holes in the latch are
slotted so that you can adjust the lock assembly.
5
Installing the Hood Handle
Parts needed for this procedure:
1
Hood handle
2
Bolt (1/4 x 1-1/8 inch)
2
Washer (5/16 inch)
1
Clamp
Procedure
1.
Locate the hood support rail on the inside of the
left side of the hood.
2.
Measure along the rail, from the support edge,
3.8 cm (1-1/2 inches) as shown in
3.
Install the clamp around the rail at this location.
4.
Using the clamp as a template, mark and drill an
8-mm (5/16 inch) diameter hole.
5.
Install a washer (5/16 inch) and bolt (1/4 x 1-1/8
inch) through the clamp and drilled hole in the
hood and into the hood handle.
6.
With the hood handle in the approximate position
shown in
Figure
Note:
The second hole is 12.2 cm (4-13/16
inch) from the first hole.
7.
Swing the hood handle out of position and drill a
5/16 inch diameter hole at the marked location.
8.
Install a washer onto the other bolt (1/4 x 1-1/8
inch) and through the hood.
9.
Secure the handle to the hood using the other
washer (5/16 inch) and bolt (1/4 x 1-1/8 inch)
as shown in
Figure
Note:
Tighten the bolts.
6).
Figure
7, mark the second hole to drill.
7.
7.
7
Advertisement
Table of Contents
