Viessmann Vitocal 200-G Series Installation And Service Instructions Manual page 80

Commissioning/service reports
Control parameter report
Parameter
Shutdown hysteresis inst. heating water
heater
Cylinder primary pump enable
Operating mode cylinder primary pump
Change in secondary pump speed during
DHW heating
Enable elec. heating/ext. HS for reheating
only
DHW heating blocking time
Max. interruption, DHW heating
Solar
Parameter
"Type solar control unit"
Parameters for solar control module, type
SM1
Electric booster heater
Parameter
"Enable instantaneous heating water
heater"
"Enable electric heaters for DHW heat-
ing"
"Enable instant. heating water heater for
central heating"
"Start delay instantaneous heating water
heater"
"Max. output instantaneous heating wa-
ter heater"
"Output for instant. heating water heater
at power-OFF"
"Dual mode temp. instant. heating water
heater"
80
(cont.)
Code Delivered condition Commission-
601E 10 (
601F 0
6020 0
6033 0
6040 60 %
6060 0 min
6061 0 min
Code Delivered condition Commission-
7A00 0
C0xx These parameters will only be displayed if the solar
control module, type SM1, is connected to the heat
pump and "Type solar control unit" is set to "3".
For a description of the parameters, see installation
and service instructions for "solar control module, type
SM1".
Code Delivered condition Commission-
7900 1
7901 0
7902 0
7905 30 min
7907 3
790A 0
790B 500 (
ing
≙
1 K)
ing
ing
≙
50 °C)
Maintenance/
service
Maintenance/
Service
Maintenance/
service