Extron electronics TLI Pro 101 User Manual page 15

HDMI Input (see figure 2
B
into this female HDMI type A connector. Secure the HDMI connector to the TLI Pro 101
with the provided LockIt HDMI lacing bracket (see "LockIt HDMI Lacing
Bracket Installation", below).
The wiring of the connector follows the HDMI single link format.
The diagram to the right and the table below show the HDMI pin
configuration.
Pin Signal
1 TMDS data 2+
2 TMDS data 2 shield
3 TMDS data 2-
4 TMDS data 1+
5 TMDS data 1 shield
6 TMDS data 1-
HDMI Output — Connect this female HDMI type A connector to a third-party touch
C
A full list of supported
screen.
following page.
LockIt HDMI Lacing Bracket Installation:
Secure the HDMI connector to the TLI Pro 101 with the provided LockIt HDMI lacing
bracket by following these instructions:
1. Plug the source HDMI cable into this
input port.
2. Loosen the HDMI connection mounting
screw from the TLI Pro 101 rear panel
enough to allow the LockIt lacing bracket
to be placed over it. The screw does not
have to be removed.
3. Place the LockIt lacing bracket on the
screw and against the HDMI connector,
then tighten the screw to secure the
bracket.
ATTENTION:
• Do not overtighten the HDMI
connection mounting screw.
The shield it fastens to is very
thin and can easily be stripped.
• Ne serrez pas trop la vis de
montage du connecteur HDMI.
Le blindage auquel elle est
attachée est très fin et peut
facilement être dénudé.
4.
Loosely place the included tie wrap
around the HDMI connector and the
LockIt lacing bracket as shown.
5. While holding the connector securely
against the lacing bracket, tighten the tie
wrap, then remove any excess length.
on page 5) — Plug the cable from the input source device
Pin Signal
7 TMDS data 0+
8 TMDS data 0 shield
9 TMDS data 0-
10 TMDS clock+
11 TMDS clock shield
12 TMDS clock-
for video output is shown on the
Screen Resolutions
1 1 1
3 3 3
4 4 4
Figure 4.
TLI Pro 101 • Panel Features
19
18
HDMI
Type A Receptacle
Pin Signal
13 CE control
14 Reserved (NC)
15 SCL
16 SDA
17 DDC/CEC ground
18 +5 V power
19 Hot plug detect
2 2 2
3
5 5 5
Securing the HDMI
Connector
1
2
8