Extron electronics TLI Pro 101 User Manual page 11

5.
Connect the power cords and power on all devices (see
Network and Power over Ethernet (PoE) Connector
ATTENTION:
• Do not power on the interfaces or control processors until you have read the
Attention on page 7 (12 VDC power supply) or on
Ne branchez pas les interfaces ou les contrôleurs avant d'avoir lu les
•
en garde page 7
PoE).
6. Set up the interface for Network Communication:
Connect the PC that you will use for setup, the control processor, and the TLI Pro 101
…
to the same Ethernet subnetwork.
Use the Setup Menu
…
set the DHCP status and, if necessary, the IP address, subnet mask, gateway, and
related settings for the interface.
7.
Configure the Interface — the Global Configurator Professional and Global Configurator
Plus Help File and the GUI Designer Help File provide step-by-step instructions and
detailed information.
The Global Configurator Professional and Global Configurator Plus Help File
includes an introduction to the software and sections on how to start a project and
configuration.
Global Scripter provides an Extron-exclusive Python library (ControlScript) and
Global Scripter modules to get you started. See the GlobalScripter Help File for more
information.
(source d'alimentation 12 VCC) ou
(see page 13) or Toolbelt (see the Toolbelt Help File) to
TLI Pro 101 • Installation Overview
Power
on page 6 or
on page 10).
page 11 (power injector).
mises
(injecteur
page 11
4