Table of Contents
Advertisement
Set-Up
Profiles
Your Avaya DECT 20DT handset can be set-up for two user-defined profiles (see below
and 20DT Menu Structures on page 5.:
• Indoors (1)
• Outdoors (2)
Within each profile you can set-up different parameters for:
• Ringer Tone :
• Ringer Volume :
• Key Click On/Volume :
• Vibrator On/Off :
• B-Answer On/Off :
• Start Volume :
• Out of Range Indicator : See page 11.
• Back Lighting On/Off :
To select Profile 1 or 2:
1.
Press MENU* and
2.
Press > until required profile appears.
3.
Press
Press MENU to finish.
* Note:
Silent Mode
If you do not want your 20DT to ring when an incoming call is presented, you can select
Silent Mode. You can also Mute your microphone during a call (see page 8).
1.
Press MENU followed by SILENT. SILENT appears and your 20DT will vibrate when
incoming calls are presented.
2.
To return to normal use, repeat the above. SILENT disappears and a tone is given.
Backlight Display
You can select if your 20DT handset display is to be backlit.
1.
Press MENU* and
2.
Press > until required profile appears.
3.
Press > until BACKLIGHT appears and then press
(Use < and > to select ON or OFF.)
4.
When done, press
5.
Press MENU to finish.
* Note:
INDeX DECT 20DT Handset User's Guide
38DHB0002UKCW – Issue 7 (10/03)
. SET PROFILE/PROFILE 1 appears.
to select profile and continue with setting up of the parameters (see above).
On older menu structures (see pages 4 and 5), after pressing MENU, press >to
display PROFILE SET UP. Press
Press
and continue from step 3.
. SET PROFILE/PROFILE 1 appears..
to save.
On older menu structures (see pages 4 and 5), after pressing MENU, press >to
display PROFILE SET UP. Press
Press
and continue from step 3.
e.g. for office working
e.g. for use in a manufacturing environment.
See page 9.
See page 9.
See page 11.
See page 11.
See page 9.
See page 8.
See page 7.
and > until required profile appears.
and > until required profile appears.
Set-Up - Page 7
.
Profiles - Page 7
Set-Up
Advertisement
Table of Contents
