Table of Contents
Advertisement
Set-Up
Profiles
Silent Mode
Backlight Display
IP Office - 20DT Handset User's Guide
40DHB0002UKCH Issue 3 (25/09/2002)
Your 20DT handset can be set-up for two user-defined profiles.
•
Indoors (1) e.g. for office working
•
Outdoors (2) e.g. for use in a manufacturing environment.
Within each profile you can set-up different parameters for:
•
Ringer Tone: See page 7.
•
Ringer Volume: See page 7.
•
Key Click On/Volume: See page 9.
•
Vibrator On/Off: See page 9.
•
B-Answer On/Off: See page 7.
•
Start Volume: See page 6.
•
Out of Range Indicator: See page 9.
•
Back Lighting On/Off: See page 5.
To select Profile 1 or 2:
1.
Press MENU and PROFILE SET UP appears.
2.
Press
and press > until required profile appears.
3.
Press
to select profile and continue with setting up of the parameters
(see above).
4.
Press MENU to finish.
You can also set your DECT 20DT handset to operate in a totally silent
mode (see below).
If you do not want your 20DT to ring when an incoming call is presented,
you can select Silent Mode (not available when twinned with a desk top
phone). You can also Mute your microphone during a call (see page 6).
1.
Press MENU followed by SILENT. SILENT appears and your 20DT will
vibrate when incoming calls are presented. Refer to page 9 for details on
how to turn the vibrating option on.
2.
To return to normal use, repeat the above. SILENT disappears and a
tone is given.
You can select if your 20DT handset display is to be backlit.
1.
Press MENU and PROFILE SET UP appears. Press
required Profile (1 or 2) then press
2.
Press > until BACKLIGHT appears and then press
(Use < and > to select ON or OFF.)
3.
When done, press
4.
Press MENU to finish.
again.
to save.
Set-Up - Page 5
and select the
.
Profiles - Page 5
Advertisement
Table of Contents
