Adding A Cisco Telepresence Presentation Codec-Cisco Telepresence System 3010 And 3210 - Cisco TelePresence System Series Hardware Upgrade Manual

Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Step 11 Power on the Cisco TelePresence system by turning the power switches to the On position for the two
left PDUs, single right PDU, and the PDU on the central display if it is present.
Write down the IP address that displays on the bottom right corner of the display screens. This is the
Note
address of the primary codec unit.
Step 12 In the browser on the computer, type in the IP address of the primary codec unit.
Step 13 Enter the required information at the login screen. The Cisco TelePresence Administrator window
appears.
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 14
window) is Enabled/Up.
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
Step 15
properly.
Navigate to the Device Information > Configuration > CUCM settings window, then perform the
Step 16
following actions:
a.
b.
If you encounter problems, you might have to reboot your presentation codec several times before it
Note
becomes active. To reboot the presentation codec, turn off and on the PDU where you plugged in the
presentation codec.
Adding a Cisco TelePresence Presentation Codec—Cisco TelePresence
System 3010 and 3210
To add the Cisco TelePresence Presentation Codec to your CTS 3010 or CTS 3210, perform the
following procedure.
Turn the power switches for the two left PDUs, single right PDU, and auxiliary control unit to the Off
Step 1
position.
The directions left and right refer to the assembly as you face the Plasma displays.
Note
The auxiliary control unit is located on the rear of the system, in the center, above the center codec.
Make sure all system power is turned off before beginning this disassembly.
Caution
OL-16441-01
In the Certificate Trust List (CTL) area, delete the Certificate Trust List (CTL) from your system by
clicking Delete CTL.
In the Use Configuration TFTP Server area, click Automatic to set TFTP conditions to their default
value and remove any alternate TFTP servers.
Cisco TelePresence Presentation Codec
Cisco TelePresence System
6-19