Cisco TelePresence System Series Hardware Upgrade Manual page 71
Hide thumbs
Also See for TelePresence System Series:
- User manual (51 pages) ,
- Quick reference manual (2 pages) ,
- Getting started manual (41 pages)
Table of Contents
Advertisement
Chapter 6
Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Step 3
Plug the jumper cords for the lights and the projector serial cable into the auxiliary control unit.
Figure 6-3
Cable Routing for Auxiliary Control Unit
Power
Projector
RJ45 Ethernet
Note
If you encounter clearance problems when you connect the serial cable to the projector, remove the
projector from the table by completing the steps in the "Replacing the Projector" section in the
"Field-Replaceable Unit Guide" chapter of the
and Field Replacement Unit
OL-16441-01
Auxiliary Control Unit
Auxiliary Control Unit
Auxiliary Control Unit
1
2
1
SERI AL PORTS
RESET
10/ 100 NETW ORK PORTS
Cisco TelePresence System 3000 Assembly, Use & Care,
Guide.
Auxiliary Control Unit
2
Primary Codec
Cisco TelePresence System
6-5
Advertisement
Table of Contents
