Cisco TelePresence System Series Hardware Upgrade Manual page 31

Chapter 3 Options for the Cisco TelePresence System 1000
Step 3 Attach the auxiliary control unit to its bracket using the supplied 5 mm screws.
Attach the bracket so that the shortest part of the bracket attaches to the wall; otherwise the unit is too
Note
wide to fit between the display supports.
If your installation uses a presentation codec, connect the Ethernet cable to the auxiliary control unit as
Step 4
follows:
•
•
Measure and drill the wall mounting holes for the auxiliary control unit. Hold the unit against the wall
Step 5
and use it as a template for the mounting holes.
Figure 3-2 Measuring and Drilling Holes for Auxiliary Control Unit
Ethernet
cables
OL-16441-01
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Connect the other Ethernet port of the auxiliary control unit to the Presentation Codec Ethernet port
(white/red Ethernet connection on the presentation codec).
Auxiliary Control Unit
Cisco TelePresence System
3-3