Pioneer AVIC-D3/XU/UC Service Manual page 236

1
Note) If no action is taken for approximately 10 seconds after LD-ON, it will be switched to LD-OFF automatically.
If F close is selected in LD-OFF state, it will become an error.
Because it will be in conflict with the safety regulation if LD_OFF is not selected within 10 seconds during
A
focus search (S character measurement mode), too, it will switch to LD-OFF after 9 seconds even if the focus
search is conducted after LD-ON.
If F close is to be selected after focus search (S character measurement mode), select Power_OFF once then
power on again before F close.
Operation cannot be made until completion of displaying the value from FE Offset to VIN_10.
[1] cannot be executed unless [5] command is executed once.
[1] Succeed to Focus Close 1 state.
[2] Execution and stop of Focus Search
[3] Execution and stop of CRG+
[4] Execution and stop of CRG-
[5] On/Off of LD
B
[6] Execution of CRG_HOME
[OK] Execution/stop
[BACK] 1, [X-3212 Servo Test]: Return to Power Off state screen.
3. [x-3212 Servo Test (2-0)]: Focus Close 1 state screen
C
D
Note) Value of the data will change upon execution of the command.
Operation cannot be made until completion of displaying the value from FE MAX to TE MIN.
[1] Succeed to Focus Close 2 state.
[2] Execution of Focus Jump
[3] Execution and stop of CRG+
[4] Execution and stop of CRG-
[OK] Execution/stop
[BACK] 1, [X-3212 Servo Test]: Return to Power Off state screen.
E
F
236
1
2
AVIC-D3/XU/UC
2
3
3
4
4