Phase Adjustment - Pioneer AVIC-D3/XU/UC Service Manual

5

6.6 PHASE ADJUSTMENT

[Operational specifications]
• If the monitor microcomputer is reset while the [PHTEST] terminal is set to Low, the system will proceed to
[PHASE adjustment mode]. (You can get the same result by resetting, but it is not recommended as you will
lose the user data.)
• The key operations under this test mode are as follows.
(1): Main body key
Key
MENU
Upward search of selection item
MAP
Downward search of selection item If pressed when the cursor is pointing the lowest item in a page, the cursor will move to the top item.
|<<
Adjustment value DOWN on the selected item
>>|
Adjustment value UP on the selected item
(2): Remote controller key (CXC6317 SW1 : AVH, SW2 : AVH)
Key
Upward search of selection item
Downward search of selection item
Adjustment value UP on the selected item
Adjustment value DOWN on the selected item
• A method to cancel [PHASE adjustment mode] is described below.
ACC OFF ON. (BUP OFF
* The preset value is first written in the EEPROM, then read out and displayed.
Writing and reading are made in 16 bits. Depending on the setting item, the number of bit may be different.
5
6
Operation
If pressed when the cursor is pointing the top item in a page, the cursor will move to the lowest item.
Operation
If pressed when the cursor is pointing the lowest item in a page, the cursor will move to the top item.
If pressed when the cursor is pointing the top item in a page, the cursor will move to the lowest item.
ON will do too.)
AVIC-D3/XU/UC
6
7
Remarks
Remarks
7
8
A
B
C
D
E
F
213
8