Removal And Replacement; Preparing The Removal; Removal; Preparing Components For Storage/Further Use - Bosch Rexroth VT-VPCD Series Operating Instructions Manual

52/60

Removal and replacement

Bosch Rexroth AG, VT-VPCD, RE 30028-B/09.13
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
11 Removal and replacement

11.1 Preparing the removal

Removal carried out improperly!
The control electronics may be destroyed!
▶ Decommission the entire system as described in the general instructions for the
system.
▶ Disconnect the control electronics and all connected components from the
power supply.

11.2 Removal

Loosen the two mounting screws on the front panel and take the control electronics
from the plug-in connection without applying any force.

11.3 Preparing components for storage/further use

To prepare the VT-VPCD for storage or further use, proceed as follows:
▶ Whenever possible, use the original packaging for storage or use another, suitable
ESD packaging and observe ESD regulations.
▶ Adhere to the permitted storage temperature range, which is specified in
RE 30028.
▶ Protect the control electronics against dust and humidity.

12 Disposal

12.1 Environmental protection

Careless disposal of the VT-VPCD and the packaging material could lead to pollution
of the environment.
▶ Therefore, dispose of the VT-VPCD and the packaging material in accordance
with the currently applicable regulations in your country and provide for recycling
whenever possible.

13 Extension and conversion

The control electronics VT-VPCD must neither be extended nor converted.
Converting the VT-VPCD renders the warranty void.
+44 (0)1204 699 959
enquiries@hyquip.co.uk
www.hyquip.co.uk/web/index
NOTICE