Fuse Replacement - Bosch Rexroth IndraControl L45 Project Planning Manual

DOK-CONTRL-ICL45L65L85-PR01-EN-P
Rexroth IndraControl L45/L65/L85 Control
Changing a terminal
8.2.4

Fuse Replacement

Fig.8-3: Removing a terminal
If you want to replace a terminal within the Rexroth Inline station, proceed as
described above to remove it. Do not latch on the adjacent connector of the
neighboring terminal to the left yet.
Fit a new terminal. Subsequently, refit all connectors.
f segment terminals with fuse are used, the connected voltage and the state of
the fuse are monitored and indicated by diagnostics indicators.
A missing fuse is to be installed; a defective fuse is to be replaced.
When replacing the fuse, please observe the following instructions on the safety
of your health and the protection of your station!
1. Always use the screwdriver with care to prevent yourself and any other
person from being injured
2. Pry out the fuse at the metal contact. Do not pry the fuse out at the glass
body to prevent the latter from being broken
3. Pry out the fuse carefully on one side and then remove it by hand. Take
care not to drop the fuse into your station
Proceed as follows to replace the fuse. Also see the illustrations in
"Fuse replacement" on page
● Swing up the fuse lever (A)
● Put a screwdriver behind a metal contact of the fuse (B)
● Carefully pry out the metal contact of the fuse (C)
● Remove the fuse by hand (D)
● Latch in the new fuse (E)
● Press the fuse lever down again until it clicks into place (F)
Bosch Rexroth AG
Installation and Maintenance
54:
53/81
fig. 8-4