Bosch Rexroth VT-VPCD Series Operating Instructions Manual page 34

34/60 Installation
Bosch Rexroth AG, VT-VPCD, RE 30028-B/09.13
Hyquip Limited New Brunswick Street Horwich Bolton Lancashire BL6 7JB UK
Company Registered in England No: 4167649 VAT Registration No: 732 5692 25 BS EN ISO 9001:2008 No: LRQ 0964389
4 2
1 3
Fig. 17: Connection of swivel angle transducer AWXF004D01
The transducer is connected using a 4-pin mating connector Pg7-G5W1F, which must
be ordered separately stating material no. R900023126.
Up to a length of 50 m we recommend the use of a connection cable 4 x 0.25 mm²
of type LiYCYCY. When double shielded cable is used, the outer shield can be
terminated at the entry into the control cabinet, the inner shield can be terminated
at the control electronics.
Oil-immersed pump:
In conjunction with this pump type, the swivel angle transducer is installed oil-
immersed. We recommend the use of cable type ÖLFLON® PTFE/FEP 4 x 0.25 mm²
(by Lapp Kabel).
When double shielded cable is used, the outer shield can be terminated at the
entry into the control cabinet, the inner shield can be terminated at the control
electronics.
4
3
2
1
5
Fig. 18: Connection of swivel angle transducer DK100
Swivel angle transducer DK100 can be connected using a 5-pin mating connector
130-9 IEC-22 to DIN 45 321, which can be ordered separately.
Up to a length of 50 m we recommend the use of 4 x 0.25 mm² cables of type
LiYCYCY as connection cable. When double shielded cable is used, the outer shield
can be terminated at the entry into the control cabinet, the inner shield can be
terminated at the control electronics.
Depending on the mechanical mounting of the swivel angle transducer, positive
feedback may occur. In this case, exchange connections f20 and f26.
A2V...EO4 housing pump: Type MCP-40/4742
The Figure below shows the connection of the swivel angle transducer.
+44 (0)1204 699 959
enquiries@hyquip.co.uk
www.hyquip.co.uk/web/index
f22
f20
f24
f26
z10
f20
f22
f24
f26
z10