Table of Contents
Advertisement
Chapter 3: Connecting the Router
3.1 System Requirements
Broadband Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable modem that has an RJ45 connector (you do not need it if you
connect the router to Ethernet)
Each PC on the LAN needs a working Ethernet Adapter and an Ethernet cable with
RJ45 connectors
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator
6.0 or later
3.2 Installation Environment Requirements
Not in direct sunlight or near a heater or heating vent
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on
all sides of the router
Well ventilated (especially if it is in a closet)
Operating temperature: 0℃~40℃ (32℉~104℉)
Operating Humidity: 10%~90%RH, Non-condensing
3.3 Connecting the Router
Before you install the router, you should connect your PC to the Internet through your
broadband service successfully. If there is any problem, please contact your ISP. After
that, please install the router according to the following steps. Don't forget to pull out the
power plug and keep your hands dry.
1.
Power off your PC(s), Cable/DSL modem, and the router.
2.
Locate an optimum location for the router. The best place is usually near the center
of the area in which your PC(s) will wirelessly connect. The place must accord with
the
Installation Environment
3.
Adjust the direction of the antenna. Normally, upright is a good direction.
4.
Connect the PC(s) and each Switch/Hub on your LAN to the LAN Ports on the router,
shown in figure 3-1.
5.
Connect the DSL/Cable Modem to the WAN port on the router, shown in figure 3-1.
6.
Connect the AC power adapter to the AC power socket on the router, and the other
end into an electrical outlet. The router will start to work automatically.
7.
Power on your PC(s) and Cable/DSL modem.
TL-WR641G
108M Wireless Router User Guide
Requirements.
- 6 -
Advertisement
Table of Contents
