Chapter 2. Connecting The Router; System Requirements; Installation Environment Requirements; Connecting The Router - TP-Link TL-WR710N User Manual

Chapter 2. Connecting the Router

2.1 System Requirements

Each PC in the LAN needs a working Ethernet Adapter
TCP/IP protocol must be installed on each PC
Web browser, such as Microsoft Internet Explorer 5.0 or later, Mozilla Firefox, Apple Safari
If the device is configured to Wireless Router/Access Point mode, you also need Broadband
Internet Access Service (DSL/Cable/Ethernet)
One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is
connected directly to the Ethernet.)

2.2 Installation Environment Requirements

Place the Router in a well-ventilated place far from any heater or heating vent
Place the Router in a location where it can be connected to the various devices as well as to
a power source
Avoid direct irradiation of any strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the Router
Operating Temperature: 0 ~40
Operating Humidity: 10%~90%RH, Non-condensing

2.3 Connecting the Router

Before installing the Router, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact with your ISP. To connect the Router, please
follow the steps below:
1. Power off your PC, Cable/DSL Modem, and the Router.
2. Locate an optimum location for the Router. The best place is usually at the center of your
wireless network. The place must accord with the
3. Plug the power plug in the electrical wall socket. The Router will start to work automatically.
After finishing the steps above, please choose the operation mode you need and carry out the
corresponding steps. There are five operation modes supported by this router: Wireless Router,
Access Point, Repeater, Client and WISP Client Router.
TL-WR710N 150Mbps Wireless N Mini Pocket Router
(32 ~104 )
℃ ℃ ℃ ℃
- 5 -
Installation Environment Requirements.