TP-Link TL-WR641G User Manual page 17

108mbps wireless router
Hide thumbs Also See for TL-WR641G:
Table of Contents

Advertisement

contact your ISP.
If you choose " Dynamic IP", the router will automatically receive the IP parameters from
your ISP without needing to enter any parameters.
If you Choose "Static IP", the Static IP settings page will appear, shown in figure 4-8:
Note: The IP parameters should have been provided by your ISP.
IP Address - This is the WAN IP address as seen by external users on the Internet
(including your ISP). Enter the IP address into the field.
Subnet Mask - The Subnet Mask is used for the WAN IP address, it is usually
255.255.255.0
Default Gateway - Enter the gateway into the box if required.
Primary DNS - Enter the DNS Server IP address into the boxes if required.
Secondary DNS - If your ISP provides another DNS server, enter it into this field.
After you complete the above, click Next, the Wireless settings page will appear, shown
in figure 4-9.
In this page, you can configure the following wireless parameters:
Wireless Radio - indicates whether the Access Point feature of the router is
enabled or disabled. If disabled, the WLAN LED on the front panel will not be lit and
the wireless stations will not be able to access the router. If enabled, the WLAN
LED will be lit up and wireless stations will be able to access the router.
SSID - Enter a value of up to 32 characters. The same SSID must be assigned to
TL-WR641G
Figure 4-8 Quick Setup - Static IP
Figure 4-9 Quick Setup - Wireless settings
- 11 -
108M Wireless Router User Guide

Advertisement

Table of Contents
loading

Table of Contents