Lan; Wan - TP-Link TL-WR641G User Manual

108mbps wireless router

Hide thumbs Also See for TL-WR641G:

Table of Contents

5.4.1 LAN

You can configure the IP parameters of LAN on this page.

MAC Address - the physical address of the router, as seen from the LAN. The

value can't be changed.

IP Address - Enter the IP address of your router in dotted-decimal notation

(factory default: 192.168.1.1).

Subnet Mask - An address code that determines the size of the network. Normally

use 255.255.255.0 as the subnet mask.

Note:

If you change the IP Address of LAN, you must use the new IP Address to login the

router.

If the new LAN IP Address you set is not in the same subnet, the IP Address pool in

the DHCP sever will not take effect, until they are re-configured.

If the new LAN IP Address you set is not in the same subnet, the Virtual Server and

DMZ Host will change accordingly at the same time.

You can configure the WAN port parameters on this page.

First, please choose the WAN Connection Type (Dynamic IP/Static IP/PPPoE) to the

Internet. The default type is PPPoE. If you aren't given any login parameters (fixed IP

Address, logging ID, etc), please select Dynamic IP. If you are given a fixed IP (static

IP), please select Static IP. If you are given a user name and a password, please select

PPPoE

If you are not sure which connection type you use currently, please contact

your ISP to obtain the correct information.

If you choose Dynamic IP, the router will automatically get IP parameters from

your ISP. You can see the page as follows (figure 5-4):

TL-WR641G

108M Wireless Router User Guide

Figure 5-3

- 15 -

LAN

Table of Contents