Checking The Brake-Fluid Level; Changing The Brake Fluid - Toro Workman 07235 Operator's Manual

Checking the Brake-Fluid
Level
Service Interval: Before each use or daily—Check
the brake-fluid level. Check the
brake-fluid level before you first start
the engine.
Brake-fluid type: DOT 3
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Raise the hood to access to the master brake
cylinder and reservoir
Figure 67
1. Filler neck (reservoir)
2. Reservoir cap
5. Look at the outline of the fluid level at the side of
the reservoir (Figure
Note:
The level should be above the Minimum
line.
Figure 68
1. Brake-fluid reservoir
6. If the fluid level is low, preform the following:
A. Clean the area around the reservoir cap
and remove the cap
(Figure 67).
3. DOT 3 brake fluid
68).
2. Minimum line
(Figure 67).
B. Add DOT 3 brake fluid to the reservoir until
the fluid level is above the Minimum line
(Figure
Note:
brake fluid.
C. Install the reservoir cap
7. Close the hood.

Changing the Brake Fluid

Service Interval: Every 1,000 hours
Contact your authorized Toro distributor.
g033037
g002136
52
68).
Do not overfill the reservoir with
(Figure 67).