Breaking In A New Machine; During Operation; During Operation Safety - Toro Workman 07235 Operator's Manual

•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or fuel
containers over the winter unless a fuel stabilizer
is used.
•
Do not add oil to gasoline.
Filling the Fuel Tank
The fuel-tank capacity is approximately 26.5 L (7 US
gallons).
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the area around the fuel-tank cap
13).
1. Empty
2. Full
3. Needle
5. Remove the fuel-tank cap.
6. Fill the tank to about 25 mm (1 inch) below the
top of tank, (bottom of the filler neck).
Note:
This space in the tank allows fuel to
expand. Do not overfill the fuel tank..
7. Install the fuel-tank cap securely.
8. Wipe up any fuel that may have spilled.

Breaking in a New Machine

Service Interval: After the first 100 hours—Perform
the guidelines for breaking in a new
machine.
Perform the following guidelines to provide proper
performance for the machine.
•
Ensure that the brakes are burnished; refer to
Burnishing the Brakes (page
Figure 13
4. Fuel gauge
5. Fuel-tank cap
8).
•
Check the fluid and engine-oil levels regularly.
Remain alert for signs that the machine or its
components are overheating.
•
After starting a cold engine, let it warm up for about
15 seconds before using the machine.
Note:
when operating in cold temperatures.
•
Vary the machine speed during operation. Avoid
fast starts and quick stops.
•
A break-in oil for the engine is not required.
Original engine oil is the same type specified for
regular oil changes.
•
Refer to
low-hour checks.
(Figure
•
Check the front suspension positioning and adjust
it, if necessary; refer to
Alignment (page

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Passengers should sit in the designated seating
positions only. Do not carry passengers in the
g008398
cargo bed. Keep bystanders and pets away from
the machine during operation.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear dangling jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Operate the machine outdoors or in a
well-ventilated area only.
•
Do not exceed the maximum gross vehicle weight
(GVW) of the machine.
•
Use extra caution when operating the machine
with a heavy load in the cargo bed. The heavier
the load, the more difficult it is to turn or stop.
•
Carrying oversized loads in the cargo bed reduces
the stability of the machine.
•
Carrying material that cannot be bound to the
machine, such as a large tank of liquid, adversely
affects the steering, braking, and stability of the
machine.
•
Before you start the engine, ensure that the
4 transmission is in neutral, the parking brake is
engaged, and you are in the operating position.
16
Allow more time for the engine to warm up
Maintenance (page 24)
Adjusting the Front Wheel
46).
for any special,