Reducing The Top Speed - Toro Workman 07235 Operator's Manual

1. Cover
3. Thoroughly clean the inside of the cover and
the inner components of the clutch using
compressed air.
4. Install the clutch cover and secure it with the 3
bolts (Figure 63) that you removed in 2.
5. Lower the cargo bed; refer to
Cargo Bed (page

Reducing the Top Speed

CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1. Raise and latch the cargo bed; refer to
the Cargo Bed (page
2. Remove the bolts securing the primary clutch
cover as shown in
Important:
Use caution when removing
the clutch cover; the spring is under
compression.
Important:
Take note of the X orientation
on the clutch covers and clutch assemblies
for later installation.
Figure 63
2. Bolts
Lowering the
19).
18).
Figure 64.
g011947
1. Clutch spacer
3. Remove the spring.
4. Add or remove spacers to adjust the top speed.
Use the following table to determine the amount
of spacers needed.
Spacers
2 (standard)
3
4
5
6
Important:
without at least 2 clutch spacers in place.
5. Install the spring and clutch cover.
Important:
in the original location.
6. Torque the bolts to 179 to 228 N–m (132 to 168
in-lbs).
Raising
49
Figure 64
Top Speed
16 mph (standard)
12 mph
9 mph
6 mph
4 mph
Do not operate the machine
Ensure that the X is placed back
g026341