Chassis Maintenance; Adjusting The Cargo-Bed Latches; Cleaning; Washing The Machine - Toro Workman 07235 Operator's Manual

Chassis Maintenance

Adjusting the Cargo-Bed
Latches
If the cargo-bed latch is out of adjustment, the cargo
bed vibrates up and down as you drive the machine.
You can adjust the latch posts to make the latches
hold the cargo bed snugly to the chassis.
1. Loosen the locknut on the end of the latch post
(Figure 71).
Figure 71
1. Latch
2. Locknut
2. Rotate the latch post clockwise until it is snug
against the hook portion of the latch
3. Torque the locknut to 19.7 to 25.4 N∙m (175 to
225 in-lb).
4. Repeat this steps
the other side of the machine.
3. Latch post
(Figure
1 through 3 for the latch on

Cleaning

Washing the Machine

Wash the machine as needed. Use water alone or
with a mild detergent. You can use a rag.
Important:
Do not use pressurized water when
washing the machine. It may damage the electrical
system, loosen important decals, or wash away
necessary grease at friction points. Avoid
excessive use of water, especially near the control
panel, engine, and battery.
g002181
71).
54