Basic Connection - EverFocus eZ.HD ELUX4 Quick Installation Manual

3. Basic Connection

The instructions figure below describes the basic connection for the ELUX4 / ELUX8 / ELUX16
DVR. (This figure uses ELUX4 DVR as an example).
1. Connect the cameras to the DVR using the coaxial cables. (HD-CVI and HD-SDI cameras are
not supported).
2. To view videos and control OSD settings, connect a monitor to the HDMI / VGA port using the
HDMI / VGA cable supplied by the monitor manufacturer.
3. Connect the line level audio input devices to the Audio-in of the DVR. Note that the audio
input devices, such as microphones, are required to have a (built-in) amplifier and external
power supply.
4. To listen to audio of video source, connect speakers to the Audio-out RCA port. Note that
speakers with a (built-in) amplifier and external power are required.
5. Use a standard RJ-45 cable to connect the DVR to the network for remote viewing or using
EverFocus surveillance system (VANGUARD CMS) .
6. Optionally connect a mouse to the DVR to control the system. You can also control the
system using the supplied IR Remote Control or the control keys on the front panel.
7. Using the supplied Power Cord, connect one end to the DC 12V port on the DVR and the
other end to the DC 12V power outlet .
Note: Please ensure to connect the internal power cables to the internal HDDs before
powering on the DVR.
Camera
1
Line Level
4
Audio Out
Main Monitor
(HDMI)
2
ELUX4 / ELUX8 / ELUX16 Full HD Hybrid DVR
Main Monitor
Line Level
3
(VGA)
2
Audio In
Network
5
Web Remote
VANGUARD CMS
Client
11
Power
7
Supply
Mouse
6