Table of Contents
Advertisement
2.3 Rack Mount
To install rack ears on the DVR:
1. Unscrew the four M3 (φ6.8) screws on both side of the DVR.
2. Use the supplied two rack ears and the above screws for rack mount installation on both side.
3. Basic Connection
2
Camera 1~16
1. To record videos, install 3.5" HDD(s) to the DVR. Please refer to 2.1 Hard Disk Installation.
2. Connect the TVI/AHD/SD cameras to the BNC ports.
3. Connect microphones to the audio input ports to transmit audio from the camera to the DVR.
Note that the microphones with a (built-in) amplifier and external power supply are
required.
4. To view videos at local site, connect a monitor to the HDMI or VGA port using the HDMI or
VGA cable supplied by the monitor manufacturer.
5. To listen to the audio from device side, connect speakers to the audio output. Note that the
speakers with a (built-in) amplifier and external power supply are required.
6. Use a standard RJ-45 CAT5 Ethernet cable to connect the DVR to the network and then
optionally connect IP cameras to the DVR.
7. Optionally connect a mouse to the DVR to control the system. You can also control the
system using the supplied IR Remote Control).
8. Use the supplied Power Cord and Adaptor to connect the DVR to the power outlet.
Line Level
3
Audio Input
1
3.5" HDD
VANGUARD
Line Level
5
Audio Out
Network
Web Remote
CMS
Client
4
4
(HDMI / VGA)
7
6
IP Camera
Mouse
Monitor
8
Power
supply
Advertisement
Table of Contents
