Turning On/Off The Power - EverFocus eZ.HD ELUX4 Quick Installation Manual

3.3 RS-485 Port
The RS-485 port, located on the rear panel of the DVR, can be used to connect to an RS-485
keyboard, such as EverFocus' EKB500, for controlling PTZ cameras or connect to a POS device. For
details on the RS-485 configurations on the DVR, please refer to 6.9.5 I/O Control in the User's
Manual. This figure uses ELUX4 DVR as an example.
Note: EverFocus full HD DVRs supports the eZ.Controller function, which enables users to
control PTZ camera from DVR using only a coaxial cable without the need of a RS-485 cable
between the PTZ camera and the DVR. Users can also enter the PTZ camera's OSD menu
through DVR (see 1.3 eZ. Controller Function Description).
4. Turning On / Off the Power
Before powering on the DVR, please make sure the internal HDDs have been installed properly.
Once you have completed the basic cable connections, you are ready to turn on the DVR.
To turn on the power, connect the supplied Power Cord to the power outlet and turn on the
Power Switch. All of the LED indicators on the front panel will light up. The DVR will automatically
run an internal process, when the process is complete, the LED indicators will turn off, and the
POWER LED will remain light up in green. And then you can start operating the DVR.
To turn off the power, please go to OSD Root Menu > System Setting > Miscellaneous setting page,
and click Shutdown (refer to 6.9.7 Miscellaneous in the User's Manual). After the message pops
up as below, you can now turn the Power Switch to the "Off" position.
ELUX4 / ELUX8 / ELUX16 Full HD Hybrid DVR
Rear View
RJ-45 Cable
PTZ Camera
14
RS-485 Port
EKB500