Siemens SIMATIC ET 200SP Manual page 39

Port parameter
The following figure shows an extract from the structure of the port parameter.
Activate a parameter by setting the corresponding bit to "1".
If you have selected IO-Link Manual operating mode, you must enter the Vendor ID
(byte x+5 and x+6) and Device ID (byte x+7 to x+10) yourself.
You can find the Vendor ID and Device ID in the IODD of the IO-Link device being used.
Communication module IO-Link Master CM 4xIO-Link (6ES7137-6BD00-0BA0)
Manual, 10/2017, A5E03856846-AD
A.1 Parameter assignment and structure of parameter data set
Parameter data record
39