Reset Communication Module To Factory Settings - Siemens SIMATIC ET 200SP Manual

Product overview

2.5 Reset communication module to factory settings

2.5 Reset communication module to factory settings
Effects of resetting to the factory settings
Use the "Reset to factory settings" function to restore the parameter assignments of your
IO-Link Master CM 4xIO-Link communication module made with S7-PCT to the factory state.
After a "Reset to factory settings", the parameters of the IO-Link Master CM 4xIO-Link
communication module are assigned as follows:
● The ports are in DI mode
● The ports are mapped to the relative addresses 0.0 ... 0.3
● The PortQualifier is disabled
● I&M data 1 to 3 is deleted
● The electronic coding element (if it exists) is deleted
Note
The device parameters are deleted and the factory state is restored.
You should reset a removed IO-Link Master CM 4xIO-Link communication module to the
factory settings before you place it in storage.
Procedure
To perform a "Reset to factory settings", proceed as described in the S7-PCT online help.
16
Communication module IO-Link Master CM 4xIO-Link (6ES7137-6BD00-0BA0)
Manual, 10/2017, A5E03856846-AD