A1.3.3 Detection Area Of The Reflective Sensor; A1.3.4 Effective Print Area - Toshiba TEC B B-SX5T SERIES Owner's Manual

APPENDIX 1 SPECIFICATIONS
A1.3.2 Detection Area of the Transmissive Sensor (Cont.)
<Tag paper with square holes>
NOTE:
Round holes are not acceptable.
A1.3.3 Detection Area of the Reflective Sensor
The Reflective Sensor is movable from the centre to the left edge of media.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm.
The Reflective Sensor should be aligned with the centre of the Black Mark.
Sensor should be positioned at
the centre of the black mark.
A1.3.4 Effective Print Area
The figure below illustrates the relation between the head effective print width and media width.
Out of print range
Sensor position
Min. 2.0 mm
Min. 12 mm
Min. 2.0 mm
Min. 12 mm
6.0
mm
(Head Effective Print Range)
140 mm (Max. media width)
Centre of media
Sensor is movable
within this range.
Centre of media
Sensor is movable
within this range.
128.0 mm 0.2
6.0
mm
EA1- 4
ENGLISH VERSION EO1-33036
Print side
Square holes
(Round holes are not acceptable.)
Media feed direction
Detecting the black
marks on the back.
Media feed direction
Out of print range
A1.3 Media