Toshiba TEC B B-SX5T SERIES Owner's Manual page 20

2. PRINTER SETUP
2.7 Loading the Media
(Cont.)
NOTE:
Be sure to set the Selection
Switch to REWINDER position.
ADJUSTMENT:
If the media skews when using
the Built-in Rewinder, turn the
Adjustment Knob of the
Rewinder Guide Plate to correct
the media feed. Clockwise turn
moves the Rewinder Guide Plate
forward and counter-clockwise
moves it backward.
When the media skews to the
right:
Loosen the SM-4x8 screw, turn
the Adjustment Knob clockwise,
and then tighten the SM-4x8
screw when the Rewinder Guide
Plate is positioned correctly.
When the media skews to the left:
Loosen the SM-4x8 screw, turn
the Adjustment Knob counter-
clockwise, and tighten the SM-
4x8 screw when the Rewinder
Guide Plate is positioned
correctly.
Build-in rewinder mode
When the Rewinder Guide Plate is attached, the Take-up Spool can be
used as a Built-in Rewinder to take up the printed media.
(1) Remove the two Black Screws to detach the Front Plate.
Front Plate
Black Screw
(2) Attach the Rewinder Guide Plate to the Strip Plate with the SMW-
4x8 sems screws.
Rewinder
Guide Plate
(3) Insert the media under the Rewinder Guide Plate.
(4) Wind the media onto the Take-up Spool and fix it in position with
the Take-up Clip.
(5) Rotate the Take-up Spool counterclockwise a few times to remove
any slack in the media.
(6) Set the Selection Switch mounted on the Rewinder Assembly to
REWINDER position.
Rewinder
Guide Plate
E2-10
ENGLISH VERSION EO1-33036
2.7 Loading the Media
SMW-4x8 Screw
Adjustment Knob
SM-4x8 Screw