A1.4 Ribbon - Toshiba TEC B B-SX5T SERIES Owner's Manual

APPENDIX 1 SPECIFICATIONS
A1.3.4 Effective Print Area (Cont.)
The figure below shows the effective print area on the media.
NOTES:
1. Be sure not to print on the 1.5-mm wide area from the media edges (shaded area in the above figure).
Printing this area may cause ribbon wrinkles, resulting in a poor print quality of the guaranteed print area.
2. The centre of media is positioned at the centre of the Print Head.
3. Print quality in the 3-mm area from the print head stop position (including 1-mm non-printable area for print
speed slow down) is not guaranteed.

A1.4 Ribbon

Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a TOSHIBA TEC service
representative.
Type
Width
Length
Outside Diameter
The table below shows the correlation between ribbon width and media width (backing paper is not included.)
Ribbon width
41 mm
50 mm
68 mm
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. To avoid ribbon wrinkles use a ribbon that is wider than the media by 5 mm or more. However, too much
difference in width between the two may cause wrinkles.
3. When using a 134 mm wide media, be sure to use a 130 mm wide ribbon. Use of other ribbons may cause
ribbon wrinkles.
Start line
1.5 mm from the
left edge of media
(backing paper width is not included.)
Spool type
68 – 134 mm
Recommended width is 41, 50, 68, 102, and 134 mm.
600 m
90 mm (max.)
Media width
30 – 36 mm
36 – 45 mm
45 – 63 mm
Area to be detected.
1mm
Guaranteed print area
1mm
Media width
Ribbon width
102 mm
134 mm
EA1- 5
ENGLISH VERSION EO1-33036
Media height
10 – 1500 mm
1.5 mm from the
right edge of media
Media feed direction
Area to be detected.
Media width
63 – 97 mm
97 – 140 mm
A1.4 Ribbon