Toshiba TEC CB-416-T3-QQ Owner's Manual page 107

A5.4 Parameter
Setting (Cont.)
Note:
See A5.7.4 for further information
about the pulse motor speed.
Note:
Use the FEED or RESTART key
to select a desired value.
Specifying the Control Code Selection Method
CODE
Select the Control Code methods: "AUTO" (automatic selection),
or "ESC, LF, NUL" or "{, ,}" or (manual selections).
After selecting the method, press the PAUSE key.
PULSE MOTOR AUTO
Select one of the following pulse motor speeds: AUTO or 104.
If selecting "AUTO", the pulse motor cycle varies depending on
the operating temperature. If "104" is selected, the pulse motor
cycle is fixed at 104%.
After selecting the pulse motor speed, press the PAUSE key.
Specifying the Euro Code
EURO CODE
Select one of the following Euro codes: FFH, FEH to B0H, B0H
to 21H or 20H.
After selecting the Euro code, press the PAUSE key.
The message returns to "PRINTER PARA".
Adjusting the Pulse Motor Speed
PRINTER PARA
After "PRINTER PARA" appears, press the FEED key.
PM ADJUST
To make a fine adjustment of the pulse motor speed, press the
PAUSE key.
PM ADJ.
The acceptable values are -60 to +60. As the value becomes lower,
the motor speed becomes faster.
After adjusting the pulse motor speed, press the PAUSE key.
The message returns to "<2> PARAMETER SET".
Appendix 5
AUTO
B0
+0
System Mode
99