Toshiba TEC CB-416-T3-QQ Owner's Manual page 22

2.5 Loading the
Media (Cont.)
Note:
Make sure that the leading edge of
media is cut straight before inserting
the media into the printer, as this may
cause a media jam.
Right Wrong
CAUTION!
Do not over tighten the two
screws, as this may cause
damage to the Media Guides.
14
14 Loosen the two screws. Slide the Media Guides in the direction
of the arrows below until they stop (completely open).
15 Unroll about 1.5 to 2 inches (40 to 50cm) of the media.
16 Insert the media into the Media Inlet. Make sure that the media
passes under the Media End Sensor, the media sensor and the
Media Pressure Plate.
Media End Sensor
Media Sensor
Media Pressure Plate
According to the media is loaded, adjust the position of the
media sensor. See Section 2.6 for more detail.
Whenever the type of media is changed, adjust sensitivity
of the media sensor. See Section 2.7 for more detail.
17 Slide the Media Guides in the direction of the arrows below until
both guides come in contact with the media (media should be in
center of media path). Hand tighten the two screws.
Screw
Media Guide
Media Guide
Chapter 2 Printer Installation
Screw
Media Guides
Important!
Screw
Screw