Table of Contents
Advertisement
Stepping C Sources
Limitations,
Restrictions
Foreground Monitor
Sleep and Software
Stand-by Mode
Store Condition and
Trace
set source on inverse_video on
<RETURN>
You can direct the emulator to execute a line or a number of lines at a
time. For example, to step one line from address _main, enter the
following command.
step source from _main <RETURN>
To step 1 line from the current line, enter the following command.
step source <RETURN>
You can specify the number of lines to be executed. To step 5 lines
from the current line, enter the following command.
step 5 source <RETURN>
Foreground monitor is not supported for the H8/338 emulator.
When the emulator breaks into the monitor, the H8/338 sleep or
software stand-by mode is released and comes to normal processor
mode. If you use the "display register" command (see the "Displaying
Registers" section of the "Getting started" chapter) at the sleep or
software stand-by mode, the emulation processor mode will come to
normal mode and the emulator will fetch next program.
Disassembling of program execution is unreliable when the emulation
analyzer is used with store condition (that is, trace only command).
Refer to chapter 2 of this manual.
Using the Emulator 5-5
Advertisement
Table of Contents
