Using The Console Port On The Supervisor Card - Cisco cBR Series Hardware Installation Manual

Installing the Supervisor in the Cisco cBR Chassis
• Memory stick or flash drive
Step 1 Open the tethered I/O door on the Supervisor Card by pulling on the left edge of the door until the door is released from
the spring-loaded ejector.
Figure 67: Opening the Tethered I/O Door on the Supervisor Card
1 Tethered I/O door
Step 2
Connect the memory stick or flash drive to the USB port on the Supervisor Card.
Figure 68: Connecting the USB Drive to the USB Port

Using the Console Port on the Supervisor Card

Before you begin
•
•
Restrictions
• When running a redundant configuration in the chassis, each Supervisor Card or Supervisor PIC must
• The console port on the Supervisor Card is for temporary connections. For permanent console connection,
Install the Supervisor PIC.
Install the Supervisor Card.
have a console port connection.
you must use the port on the Supervisor PIC.
Using the Console Port on the Supervisor Card
—
Cisco Converged Broadband Routers Hardware Installation Guide
107