Removing the Supervisor PIC from the Cisco cBR Chassis
• 3/16" flat-blade screwdriver
Step 1
Loosen the two captive screws that secure the Supervisor PIC cable management bracket using a 3/16" flat-blade
screwdriver.
Figure 128: Removing the Supervisor PIC Cable Management Bracket
1
Captive screws
Step 2
Remove the Supervisor PIC cable management bracket.
What to do next
Replace the cable management bracket
Removing the Supervisor PIC from the Cisco cBR Chassis
Perform this procedure to remove the following PIC:
• Supervisor PIC
• Blank PIC for the Supervisor
Cisco Converged Broadband Routers Hardware Installation Guide
204
Maintaining the Supervisor in the Cisco cBR Chassis
2
Supervisor PIC cable management bracket
(if required).