Table of Contents
Advertisement
Installing the Interface Line and PIC Cards
Figure 103: Opening the Spring-Loaded Ejectors on the Interface Line Card
Step 3
Grasp the faceplate of the card with one hand and place your other hand under the card to support its weight.
Step 4
Carefully align the support rails on the card with the rails in the appropriate slot.
Step 5
Slide and push the card into the slot applying even pressure using both your hands until it mates with its midplane
connectors.
Caution
To prevent damage to the midplane connector, do not use excessive force when inserting the card into the slot.
Installing the DOCSIS MAC/PHY Interface Line Card in the Cisco cBR Chassis
Cisco Converged Broadband Routers Hardware Installation Guide
147
Advertisement
Table of Contents
Troubleshooting
