Installing the Supervisor Card in the Cisco cBR Chassis
Figure 79: Closing the Spring-Loaded Ejectors on the Supervisor Card
Figure 80: Closed and Secured Spring-Loaded Ejectors on the Supervisor Card
Step 7
Tighten the two captive screws using a 3/16" flat-blade torque screwdriver with a torque of 10-12 lb-in (1.12-1.36 Nm)
to secure the card.
What to do next
• If you are using a single Supervisor Card,
•
•
Cisco Converged Broadband Routers Hardware Installation Guide
118
Connect memory stick or flash drive to use the USB port
Connect cable to use the console port
Installing the Supervisor in the Cisco cBR Chassis
install a blank card for the Supervisor
(if required).
(if required).
in the empty slot.